![]() |
|||||||||||
|
|
|||||||||||
|
|||||||||||
|
|
|
|||||||
This is a discussion on FS: Drifting Pretty Reiko Ige's Competition 240sx within the Buy and Sell Area forums, part of the Classifieds category; It's time to sell my car...It's a 1990 240sx hatch. Im the 2nd owner (I bought it stock, all mods ...
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
#1 |
|
Registered User
Join Date: Jan 2005
Posts: 59
|
FS: Drifting Pretty Reiko Ige's Competition 240sx
It's time to sell my car...It's a 1990 240sx hatch. Im the 2nd owner (I bought it stock, all mods were done by me). It has a Blacktop SR (The engine came from a complete front clip from a 98 180sx Type X with just over 45,000km on it). Not sure of the exact mileage on it now...Car will be sold as is. It is ALMOST drift ready, as my husband has pulled the LSD for his own car. Other than that, car is ready to go. Runs very strong.
Engine/Drivetrain SR20DETx Custom Exhaust (3in piping) Greddy Downpipe Koyo Radiator Walboro Fuel Pump Apexi Air Filter ACT (NS1-XTR6 kit) clutch Nismo Pivot Ball Nismo Clutch Line Nismo Slave Cylinder Nismo Tranny Mounts Wheels, Tires & Brakes Z32 Brakes/Calipers Z32 5 lug conversion Enkei RPF1 SBC F:17x8.5, +15 R:18x9.5, +15 KUMHO MX 215/45 17 (Front) KUMHO SPT 225/45 18 (Rear) Suspension Tein HE Coilovers Tein Inner Tie End Rods Tein Outer Tie End Rods Battle Version Tension Rods Battle Version Upper Control Arms Battle Version Toe Rods Battle Version Rear Forward Links C-Tune Front Strut Tower Bar C-Tune Rear Strut Tower Bar Aluminum SubFrame Spacers Exterior Custom Black Paint, with Light Blue Top Mis-matched Aero, some stickers still remain on the car Interior Custom Monstor Fabrication 6pt Roll Cage Sparco Rev Bucket Seat Sparco Seat Mount/Slider Sparco 5 Point Racing Harness Sparco Steering Wheel (Monza?) Sparco Hub Adapter, NRG Quick Release HKS Turbo Timer Spin Turn Knob The Not so Good...(But not that Bad, either...) The front lip is chipped, ding in the door, rear bumper started to rip/separate. See Pics. Front Fender (Pass Side) ripped, I carefully ziptied it back together... Asking $7000 FIRM. Located in the SGV (Pasadena/Alhambra Area) PM me here, or email me at Reiko@driftingpretty.com . Thanks for looking! |
|
|
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|