Go Back   DRIFTING.com > Classifieds > Buy and Sell Area
Register FAQ Calendar Search Today's Posts Mark Forums Read

Drift: RX7 TII with New Engine

This is a discussion on Drift: RX7 TII with New Engine within the Buy and Sell Area forums, part of the Classifieds category; I was orginally setting this car up for drifitng, but my interest has shifted elsewhere, so I am forced to ...

Reply
 
Thread Tools Rate Thread Display Modes
Old 07-23-2004, 09:43 PM   #1
eyecandy
Registered User
 
eyecandy's Avatar
 
Join Date: Jul 2004
Location: Pittsburgh, PA
Posts: 56
Send a message via AIM to eyecandy
Drift: RX7 TII with New Engine

I was orginally setting this car up for drifitng, but my interest has shifted elsewhere, so I am forced to sell her.

The ONLY problems with the car is there are about 5 small dings and one larger ding (about 3" by 3"), also a the passenger front fender needs to be resprayed due to paint cracking (its not bad, but you will only notice it fi you are right on top of it). Other than that the car is in excellent condition. The inerior is almost perfect, just your normal minor wear for a 17 year old car. Other than the MINOR exterior problems you will be HARD PRESSED to find a cleaner FC. I will gladly answer any and all questions, now onto the car!


1987 TII Black over Grey
w/74.9k on the chassis
Clean and clear PA title
VIN: JM1FC3325H0509223
Has power windows and steering, rear wiper, moonroof, AC and ABS pumps both removed (Still have both).

INFO:

NEW Reman with just about 2k miles with All new gaskets, o-rings, grommets, Vac lines, etc.
NEW MOP lines, Upper and lower radiator hoses, TPS, motor mounts, coolant level and thermo sensor, fuel filter
Racing Beat Oil Baffle plate
Injectors sent to RC for balancing and cleaning
NEW Front rotors, calipers, and pads
MazdaTrix ABS removal kit
H4 Headlight conversion
Racing Beat Toe Eliminators
Heavily ported Wastgate with a larger flapper (no more boost creep! yea!)
Calipers sprayed Red
Polished interior/exterior of UIM and LIM
Resprayed the entire underbody, fender wells, engine bay from frame rails down, front and rear subframes, halfshafts, diff, and all other rear suspension parts with a rubber based undercoating

All the above for $4100

The Above plus the following installed:
HKS FCD
Racing Beat 3" Turbo Back
Goodridge Stainless Steel Brake Lines
Corksport Stainless Steel Clutch Line
Exedy Street/Strip clutch

All for $4700

Here is a list of extra parts that I will include at an added cost, so basically you can chose what you would like to add and I will either include or install it for you if you would like. I will only part out some of the aftermarket parts if the price is right.

ELECTRONICS:
Apexi SAFC 2 (black version)
Blitz SBC Spec R
Innovate! LM-1 w/RPM convertor

ENGINE:
Blitz DD BOV
Magencor 10mm
HKS Intake
FD Alternator with twin pulley
FD Fuel Pump
Hose Techniques Silicon Vac
Koyo Radiator
FEED Radiator Caps


EXHAUST:
FEED Sonic HSr Catback (3" piping with 3.8" tip)
Racing Beat 2.5" Stainless Steel DP/MP
Magnaflow Stainless Steel Cat welded w/flanges

SUSPENSION:
Mazdatrix Camber Adjuster (non removal type)
FEED Strut tower bar
Silk Road Spec RM/A8 8/6kg w/extra set of springs 10/8kg
Super Now! Tie Rod ends w/spacer

DRIVETRAIN:
Vert wheels

EXTERIOR:
RE Amemiya Whaletail spoiler
JDM Mirrors
OEM Mudflaps
S5 Tail lights

INTERIOR:
Pioneer DEHP3600
Infinity 4" and 6.5" speakers
S5 Radio Surround and Air vents
MazdaSpeed Shift Knob

Take EVERYTHING for $11,000 OBO


Thanks for looking and hopefully we can work something out! Serious offers only! No dead beat dreamers!

Email me at Sikokillr@aol.com for pics until I get some loaded up here. Also the best way to reach me is to email me.
eyecandy is offline   Reply With Quote
Old 07-26-2004, 02:28 PM   #2
240_1693
Newbie
 
Join Date: Jun 2004
Location: Georgia
Posts: 16
Post or send me some pics please. incubus_182_1693@hotmail.com
240_1693 is offline   Reply With Quote
Old 07-26-2004, 06:48 PM   #3
eyecandy
Registered User
 
eyecandy's Avatar
 
Join Date: Jul 2004
Location: Pittsburgh, PA
Posts: 56
Send a message via AIM to eyecandy
Not all parts in the car come in the $4100 (stock) price.






















Last edited by eyecandy; 07-26-2004 at 06:51 PM.
eyecandy is offline   Reply With Quote
Old 07-29-2004, 09:33 PM   #4
eyecandy
Registered User
 
eyecandy's Avatar
 
Join Date: Jul 2004
Location: Pittsburgh, PA
Posts: 56
Send a message via AIM to eyecandy
The sale is pending right now, if all goes well it will be sold tomorrow with a lot of parts, and I will post aftere what parts are still available forsale.
eyecandy is offline   Reply With Quote
Reply

Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are Off
Pingbacks are Off
Refbacks are Off

Forum Jump


All times are GMT -7. The time now is 06:10 PM.


All times are GMT -7. The time now is 06:10 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2012, vBulletin Solutions, Inc.
Search Engine Friendly URLs by vBSEO 3.6.0