Go Back   DRIFTING.com > TECH Discussion > TECH Discussion Forum
Register FAQ Calendar Search Today's Posts Mark Forums Read

Turbo Progress - Ask Sarah Feature on Motoiq

Reply
 
Thread Tools Rate Thread Display Modes
Old 04-08-2014, 10:43 AM   #1
INFO
 
INFO's Avatar
 
Join Date: May 2004
Posts: 6,057
Send a message via AIM to INFO
Turbo Progress - Ask Sarah Feature on Motoiq

"Dear Sarah,

What are the kinds of progress that have made turbo charging so usable this decade or so? 'Back then', car reviews will tell you how severe the turbo-lag is (and the subsequent surge in power). Nowadays, many turbo cars seem to not suffer from lag to the extent that reviewers compare the power delivery to that of a N/A engine. Is it better electronic control of... stuff? Materials science? Ground-breaking inventions and improvements?

Thank you.
YW Tan"

"Material choice can greatly influence a turbo’s efficiency with lighter, stronger alloys today reducing weight and air resistance while maintaining strength. Titanium and aluminum alloys are often employed to make the turbine/compressor wheels. BorgWarner’s EFR (Engineered For Racing) turbo features a Gamma-Ti turbine wheel and shaft. Gamma-Ti is more difficult to cast but 50% lighter than its Inconel counterpart which provides better low end response and higher boost at low rpm and can provide higher overall wheel speeds. Gamma-Ti strength actually improves with more heat- it’s weakest at room temperature but during boost and driving conditions, it becomes more ductile and durable. EFR housings are also cast from stainless steel rather than the standard cast iron. This means they are lighter but also way more resistant to cracking under high temperatures. All of these advances in materials lead to greater performance and reliability.

In the past, most compressor wheels were cast aluminum. That's fine when you need cheap and mass produced but it can't offer the same strength or stability as billet aluminum. Cast aluminum products have more defects that promote stress risers, which can lead to wheel failure. To combat this weakness, the blades had to be made thicker and the center hub was beefed up. A step up is a billet wheel. Billet wheels are CNC machined from aluminum stock. They have a more homogenous grain and consistent production. "


CONTINUE HERE
http://www.motoiq.com/MagazineArticl...t-or-Bust.aspx
INFO is offline   Reply With Quote
Reply

Tags
turbo car progress

Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -7. The time now is 03:35 AM.


All times are GMT -7. The time now is 03:35 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.