Wiring harness plugs

bboyt3nsk · 02-19-2005, 10:11 AM

When doing the wiring behind the battery is it possible to just makes switches to the wires before the plugs so that the plugs from the SR and the KA align up right? or do you have to cut and splice?

thanks,
dayv

Stannyboy · 02-19-2005, 11:46 AM

why would you want to make switches.. what if your driving and it gets turned off.. why don't you either pull the wires out of the plug and re align them or just cut off the plug it self and solder it with the correct wiring diagram. and heat shrink wrap the solder parts. doesn't that seem easier then putting switches on each wire..

02-19-2005, 10:11 AM	#1
bboyt3nsk Dinosuars=Jesus Horses Join Date: May 2004 Location: Ohio(Orlando) Posts: 162	Wiring harness plugs When doing the wiring behind the battery is it possible to just makes switches to the wires before the plugs so that the plugs from the SR and the KA align up right? or do you have to cut and splice? thanks, dayv

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

02-19-2005, 11:46 AM	#2
Stannyboy Registered User Join Date: Sep 2004 Location: 818 Area... Posts: 383	why would you want to make switches.. what if your driving and it gets turned off.. why don't you either pull the wires out of the plug and re align them or just cut off the plug it self and solder it with the correct wiring diagram. and heat shrink wrap the solder parts. doesn't that seem easier then putting switches on each wire..