AGT-1500 swap in a miata

MrodDrft · 01-13-2004, 04:33 PM

Hi im new to this forum. Does anyone know where i can get a AGT-1500 swap into my 1991 miata ???

Alchemist · 01-13-2004, 05:46 PM

you could contact the US Army Tuners for an M1 body kit and some AH-64 coil overs and also APC for one of those hat clear hoods to show it off, but that i would just look silly without the M230 Chain Gun Graphics!

www.gt1500stylex.org

MrodDrft · 01-13-2004, 05:47 PM

GOOD JOB !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

hachiroku-fc3s · 01-14-2004, 09:49 AM

Mrod what is your deal with this engine. That is assuming you mean the Textron Lycoming AGT 1500 Turboshaft. When you get the clip from a M1a1. Ill help you install it. Until then, stop talking about tanks on this board. Unless you are talking about that awesome Sega GT commercial. Cracks me up every time.

MrodDrft · 01-14-2004, 10:24 PM

Im just getting sum laughs, seeing if any uninformed ppl (ricers) fall for it and then make it into the next big fad hahahaha

panda_3ight_6 · 01-15-2004, 05:59 AM

I had no idea WTF you were talking about... i was...umm ok..but whats a AGT-1500...

geuss im one those uninformed ricers...

Chas · 01-15-2004, 07:11 AM

Its a hard swap, you need to chrange out the rear diff mounts, and the airbox has to be relocated.

hachiroku-fc3s · 01-15-2004, 07:18 AM

Alternator, AC, etc. have to be moved under the car where they will need to be run off of the driveshaft which needs to be grooved for the belts. The 1500 hp is nice though.

MrodDrft · 01-25-2004, 12:32 PM

lol yea

01-13-2004, 04:33 PM	#1
MrodDrft Dorifto Pic King Join Date: Jan 2004 Location: Boston, MA Posts: 1,559	AGT-1500 swap in a miata Hi im new to this forum. Does anyone know where i can get a AGT-1500 swap into my 1991 miata ???

01-25-2004, 12:32 PM	#9
MrodDrft Dorifto Pic King Join Date: Jan 2004 Location: Boston, MA Posts: 1,559	lol yea Attached Images

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

01-13-2004, 05:46 PM	#2
Alchemist Newbie Join Date: Jan 2004 Location: Boston Posts: 13	you could contact the US Army Tuners for an M1 body kit and some AH-64 coil overs and also APC for one of those hat clear hoods to show it off, but that i would just look silly without the M230 Chain Gun Graphics! www.gt1500stylex.org

01-13-2004, 05:47 PM	#3
MrodDrft Dorifto Pic King Join Date: Jan 2004 Location: Boston, MA Posts: 1,559	GOOD JOB !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

01-14-2004, 09:49 AM	#4
hachiroku-fc3s Registered User Join Date: Dec 2003 Location: D/FW TX Posts: 549	Mrod what is your deal with this engine. That is assuming you mean the Textron Lycoming AGT 1500 Turboshaft. When you get the clip from a M1a1. Ill help you install it. Until then, stop talking about tanks on this board. Unless you are talking about that awesome Sega GT commercial. Cracks me up every time.

01-14-2004, 10:24 PM	#5
MrodDrft Dorifto Pic King Join Date: Jan 2004 Location: Boston, MA Posts: 1,559	Im just getting sum laughs, seeing if any uninformed ppl (ricers) fall for it and then make it into the next big fad hahahaha

01-15-2004, 05:59 AM	#6
panda_3ight_6 Senior Member Join Date: Nov 2003 Posts: 612	I had no idea WTF you were talking about... i was...umm ok..but whats a AGT-1500... geuss im one those uninformed ricers...

01-15-2004, 07:11 AM	#7
Chas Guest Join Date: Nov 2003 Location: Huntington Beach Posts: 2,566	Its a hard swap, you need to chrange out the rear diff mounts, and the airbox has to be relocated.

01-15-2004, 07:18 AM	#8
hachiroku-fc3s Registered User Join Date: Dec 2003 Location: D/FW TX Posts: 549	Alternator, AC, etc. have to be moved under the car where they will need to be run off of the driveshaft which needs to be grooved for the belts. The 1500 hp is nice though.