camber plates on a 240sx

kaji!_drifter · 01-13-2004, 06:38 PM

I was wondering how hard it is to put on camber plates on a 240sx? do I need special tools?

Chas · 01-19-2004, 02:07 PM

its not hard. Rachets are all that is required

PearlWhiteMike · 01-24-2004, 02:30 AM

wrong chas

youre gonna need 12mm and 17mm sockets, ratchet, 17mm box end, i think 14mm, a torque wrench, and a spring compressor. an impact gun is usually very helpful too. so no, no tools you wouldnt use just to swap out the struts. its not any harder than changing out springs, you just put on the camber plate instead of the stock upper perch.

01-13-2004, 06:38 PM	#1
kaji!_drifter I <3 japan Join Date: Jan 2004 Posts: 31	camber plates on a 240sx I was wondering how hard it is to put on camber plates on a 240sx? do I need special tools?

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

01-19-2004, 02:07 PM	#2
Chas Guest Join Date: Nov 2003 Location: Huntington Beach Posts: 2,566	its not hard. Rachets are all that is required

01-24-2004, 02:30 AM	#3
PearlWhiteMike Curb Molester Join Date: Dec 2003 Location: mira mesa Posts: 157	wrong chas youre gonna need 12mm and 17mm sockets, ratchet, 17mm box end, i think 14mm, a torque wrench, and a spring compressor. an impact gun is usually very helpful too. so no, no tools you wouldnt use just to swap out the struts. its not any harder than changing out springs, you just put on the camber plate instead of the stock upper perch.