 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
|||||||||||
|
|||||||||||
|
|||||||||||
|
|
|||||||
This is a discussion on Brake bias controller installation within the TECH Discussion Forum forums, part of the TECH Discussion category; Hey, I'm going to be redoing the brake lines on my 91 S10 Blazer and want to install a brake ...
 |
|
|
Thread Tools | Rate Thread | Display Modes |
12-29-2005, 03:16 PM
|
#1 |
|
User
Join Date: Nov 2005
Location: Akron, Oh.
Posts: 3
|
Brake bias controller installation
Hey,
I'm going to be redoing the brake lines on my 91 S10 Blazer and want to install a brake controller while I'm messing with the lines. Do you guys have any recommendations on the best way to route the brake line into the cab? I know I could mount the controller by the M/C but I don't feel like popping the hood everytime I want to adjust it. Does the fact that is a body-on-frame design make it harder to route? Any help would be greatly appreciated. Thanks 
Last edited by driftnblzr; 12-31-2005 at 10:47 AM. Reason: Posted Twice |
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
