 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
|||||||||||
|
|||||||||||
|
|||||||||||
|
|
|||||||
This is a discussion on Brake controller installation? within the TECH Discussion Forum forums, part of the TECH Discussion category; Hey, I'm redoing the brake lines on my 91 S10 Blazer that will eventually be setup for drifting. I want ...
 |
|
|
Thread Tools | Rate Thread | Display Modes |
12-30-2005, 10:40 AM
|
#1 |
|
User
Join Date: Nov 2005
Location: Akron, Oh.
Posts: 3
|
Brake controller installation?
Hey,
I'm redoing the brake lines on my 91 S10 Blazer that will eventually be setup for drifting. I want to install a bias controller inside the cab while I'm at it. What is the easiest way to install the controller? Should I route the entire line through the cab or should I just drill a couple holes and place grommets around the line and run the lines up to the controller and then back down to the frame? Any help would be greatly appreciated. Thanks |
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
