 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
|||||||||||
|
|||||||||||
|
|||||||||||
|
|
|||||||
This is a discussion on Help with ebay toe arms and RUCAs for my zenki s14 within the TECH Discussion Forum forums, part of the TECH Discussion category; I have no brand RUCAs and no brand toe arms off of ebay. I'm confused on how your suppose to ...
 |
|
|
Thread Tools | Rate Thread | Display Modes |
02-05-2006, 08:18 PM
|
#1 |
|
User
Join Date: Feb 2006
Posts: 1
|
Help with ebay toe arms and RUCAs for my zenki s14
I have no brand RUCAs and no brand toe arms off of ebay. I'm confused on how your suppose to tighten and align everything. I just need to know, because I can't make anything out of the Japanese instructions. Also this might help whoever does my alignment.
On another note my toe arms are the type with the nut at the fork end also. Do I need to adjust that out, or leave as is, and only fool with the heilm joint nut? So if you could give me any advice I appreciate it. BTW I have not guideline for bolt torque for RUCAs or toe arms. Thanks for any help, I'm new to the site |
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
