sr20 ignition issues

GotNismo? · 04-08-2006, 10:07 AM

ok the ignition stays on constantly, i cannot start the car with the key, either the ignition relays starts buzing or the acc relay on the drivers panel starts clicking, i also noticed that the relay coming off the fuse panel right underneath the clutch pedal clicks.... when i jump the starter off to start the car, i have to let 5th gear out to kil th emotor the key doesnt do anything.... i can start the car and everythign with out it. i did a auto to manual swap. but i have the wires jumped off as i should.... if any one has any clue as to how to solve this or if anyone has had this problem before any help would be much appriciated , thanks

Matt

TokyoDrifterxo7 · 04-10-2006, 03:13 AM

double check and triple check your work. If you dont see anything wrong, have someone that has done the swap look it over. I would only be able to help you if i was there to look over what you have, sorry. But here is a helpful site that you can run through and possibly find what your mistake was. http://www.srswap.com/faq/index.asp

If you still cant figure it out, post in the Zilvia.net forums, they are always helpful. best of luck

Stannyboy · 04-10-2006, 05:02 PM

agreed with tokyo.. if your car started fine with the ka.. then u wired something wrong.

04-08-2006, 10:07 AM	#1
GotNismo? But officer i swear.... Join Date: May 2004 Location: New Orleans Posts: 234	sr20 ignition issues ok the ignition stays on constantly, i cannot start the car with the key, either the ignition relays starts buzing or the acc relay on the drivers panel starts clicking, i also noticed that the relay coming off the fuse panel right underneath the clutch pedal clicks.... when i jump the starter off to start the car, i have to let 5th gear out to kil th emotor the key doesnt do anything.... i can start the car and everythign with out it. i did a auto to manual swap. but i have the wires jumped off as i should.... if any one has any clue as to how to solve this or if anyone has had this problem before any help would be much appriciated , thanks Matt

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

04-10-2006, 03:13 AM	#2
TokyoDrifterxo7 Tokyo7even Join Date: Nov 2003 Location: SoCal Posts: 295	double check and triple check your work. If you dont see anything wrong, have someone that has done the swap look it over. I would only be able to help you if i was there to look over what you have, sorry. But here is a helpful site that you can run through and possibly find what your mistake was. http://www.srswap.com/faq/index.asp If you still cant figure it out, post in the Zilvia.net forums, they are always helpful. best of luck

04-10-2006, 05:02 PM	#3
Stannyboy Registered User Join Date: Sep 2004 Location: 818 Area... Posts: 383	agreed with tokyo.. if your car started fine with the ka.. then u wired something wrong.