 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
|||||||||||
|
|||||||||||
|
|||||||||||
|
|
|||||||
This is a discussion on BEE*R REV Limiter/KA24DE within the TECH Discussion Forum forums, part of the TECH Discussion category; Anyone know the exact pins for the a BEE*R Rev limiter to work on a KA24DE ??...
 |
|
|
Thread Tools |
Rating: 
|
Display Modes |
09-13-2007, 11:52 AM
|
#1 |
|
Guest
Posts: n/a
|
BEE*R REV Limiter/KA24DE
Anyone know the exact pins for the a BEE*R Rev limiter to work on a KA24DE ??
|
|
|
06-14-2008, 12:41 PM
|
#2 |
|
User
Join Date: Jun 2008
Posts: 1
|
Not to bring up a dead thread, but since it was unanswered and my friend and I just figured this out, I thought I would post.
To use the Bee*R rev limiter on a KA24de, we connected the power and ground to the obvious sources on the ecu. The white wire connects to the ebrake switch. The green and yellow wire were a little confusing/frustrating since there were only 2 and we couldn't figure out the right combination. Green wire of the unit - slot 1 ignition signal (white) on ecu Yellow wire of the unit - slot 40 camshaft position sensor (white) on ecu Hope this helps! |
|
|
|
06-15-2008, 04:25 PM
|
#3 |
|
User
Join Date: May 2006
Posts: 18
|
i hooked mine up to the ignition signal and the tach. i never hooked up the handbrake on and make sure to cut the wire that is need for your car. gray for 4 and brown for thoses rotarys. heres the link i used
http://www.driftworks.com/resources/...itting,16.html just need to get a pinout for a ka and your set 
|
|
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
