Taking off the Dash board???

Nismo · 02-23-2004, 11:40 PM

Does anyone know how to take off the dash board???

02-24-2004, 01:14 AM

specifying a car would help your question

Nismo · 02-24-2004, 01:08 PM

91Mazda Miata

02-24-2004, 01:17 PM

lots of bolts...just remove them all

panda_3ight_6 · 02-24-2004, 07:47 PM

Everything is upside down...and its all hard to reach...

Drift For Food · 02-25-2004, 10:19 AM

All cars are basically the same when removing things, dashes, doors, seats, etc...

Basically, like said above, you've got lots of screws. You might have up to a dozen to remove. I'm not sure about the miata, but if the last 4 cars I've owned and my brother's mazda is representive of all mazdas, then yes, start unscrewing, hehe.

Remove all the screws. Afterwards, the whole dash should lift right off. Watch for some conncted wires. There may be a light or somethig attached to the dash. Just twist and remove. Don't try to force anything. If one part seems to stick, there may be a screw(s) you missed.

JunpoweR · 03-25-2004, 04:38 AM

Well start with removing the glove box..
and get under the dash..

QuickStyle · 03-25-2004, 08:54 PM

when you get all the screws out there is a wire harness that is held to underside of the dash with i lot of zip ties. you just gotta make sure you get them all

02-23-2004, 11:40 PM	#1
Nismo Guest Join Date: Jan 2004 Location: Upland, California Posts: 183	Taking off the Dash board??? Does anyone know how to take off the dash board???

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

02-24-2004, 01:14 AM	#2
____ Guest Posts: n/a	specifying a car would help your question

02-24-2004, 01:08 PM	#3
Nismo Guest Join Date: Jan 2004 Location: Upland, California Posts: 183	91Mazda Miata

02-24-2004, 01:17 PM	#4
driftfreak Guest Posts: n/a	lots of bolts...just remove them all

02-24-2004, 07:47 PM	#5
panda_3ight_6 Senior Member Join Date: Nov 2003 Posts: 612	Everything is upside down...and its all hard to reach...

02-25-2004, 10:19 AM	#6
Drift For Food OMG the ground's white! Join Date: Feb 2004 Location: Minnesota Posts: 676	All cars are basically the same when removing things, dashes, doors, seats, etc... Basically, like said above, you've got lots of screws. You might have up to a dozen to remove. I'm not sure about the miata, but if the last 4 cars I've owned and my brother's mazda is representive of all mazdas, then yes, start unscrewing, hehe. Remove all the screws. Afterwards, the whole dash should lift right off. Watch for some conncted wires. There may be a light or somethig attached to the dash. Just twist and remove. Don't try to force anything. If one part seems to stick, there may be a screw(s) you missed.

03-25-2004, 04:38 AM	#7
JunpoweR Registered User Join Date: Jul 2003 Location: ~San~Francisco~415~510~ Posts: 434	Well start with removing the glove box.. and get under the dash..

03-25-2004, 08:54 PM	#8
QuickStyle Registered User Join Date: Nov 2003 Location: hiroshima, japan Posts: 142	when you get all the screws out there is a wire harness that is held to underside of the dash with i lot of zip ties. you just gotta make sure you get them all