c33 Laurel Auto to Manaul problem

wo0dsey · 04-24-2010, 11:32 PM

I have a c33 Laurel that i just put an rb25det into and the engine mounted up fine but the gearbox mounts were 52mm out (needing to move the mounts back to the diff 52mm to bolt up).

The c33 laurel iv got used to be an auto any help please

Bebop · 04-25-2010, 09:25 AM

You might need to use a R32 trans if the motor is out of a R33 or a R34(especially) it might not mount up.

What country are you in

Most of us are Americans so we are kinda stupid when it comes to this.

QuickStyle · 04-25-2010, 09:56 PM

when i did mine i had a bracket welded on to the tranny mount...
it was a 26, but same thing

wo0dsey · 04-25-2010, 11:44 PM

Im from new zealand mate. i was just going to weld some mount brackets up for the gearbox but is a rb25det gearbox from an r33 diffrent from the orignal manual c33 laurel gearbox thanks heaps guys

QuickStyle · 04-28-2010, 08:11 PM

i used a 32 type m tranny and just fabricated a bracket to move the holes on the mount over a couple inches...

04-24-2010, 11:32 PM	#1
wo0dsey Registered User Join Date: Apr 2010 Posts: 2	c33 Laurel Auto to Manaul problem I have a c33 Laurel that i just put an rb25det into and the engine mounted up fine but the gearbox mounts were 52mm out (needing to move the mounts back to the diff 52mm to bolt up). The c33 laurel iv got used to be an auto any help please

04-25-2010, 09:25 AM	#2
Bebop Registered User Join Date: Dec 2005 Location: 951 Posts: 2,420	You might need to use a R32 trans if the motor is out of a R33 or a R34(especially) it might not mount up. What country are you in Most of us are Americans so we are kinda stupid when it comes to this. __________________ Favorite Pro: USA - JTP JAP -Tetsuya Hibino Favorite Privateer: USA -John Russakoff JAP - Mitsuru Haruguchi Favorite Overall Team Bergenholtz Favorite Course: FD - LVMS(08 setup) D1 - Bihoku Circuit

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

04-25-2010, 09:56 PM	#3
QuickStyle Registered User Join Date: Nov 2003 Location: hiroshima, japan Posts: 142	when i did mine i had a bracket welded on to the tranny mount... it was a 26, but same thing

04-25-2010, 11:44 PM	#4
wo0dsey Registered User Join Date: Apr 2010 Posts: 2	Im from new zealand mate. i was just going to weld some mount brackets up for the gearbox but is a rb25det gearbox from an r33 diffrent from the orignal manual c33 laurel gearbox thanks heaps guys

04-28-2010, 08:11 PM	#5
QuickStyle Registered User Join Date: Nov 2003 Location: hiroshima, japan Posts: 142	i used a 32 type m tranny and just fabricated a bracket to move the holes on the mount over a couple inches...