 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
|||||||||||
|
|||||||||||
|
|||||||||||
|
|
|||||||
This is a discussion on sr20det redtop ecu pinout within the TECH Discussion Forum forums, part of the TECH Discussion category; hey guys.. i have the sr in my car.. tried starting it.. it cranks but it doesnt start.. i checked ...
 |
|
|
Thread Tools | Rate Thread | Display Modes |
06-26-2004, 01:19 PM
|
#1 |
|
Registered User
Join Date: Dec 2003
Location: san diego
Posts: 70
 |
sr20det redtop ecu pinout
hey guys.. i have the sr in my car.. tried starting it.. it cranks but it doesnt start.. i checked the injectors checked the fuel pump checked the harness and all the grounds then i checked the spark plugs for sparks... no sparks... when i got the front clip the blue plug that plugs into the ecu was broken in half and most of the pins came out of it... so i had to put every pin back.. but the thing is the pins for the coil packs arent in the correct pinouts ive checked online for a eccs pinout diagram.. ive tried switching the pins around with each diagram but still no spark.. i checked the red led on the side of the ecu and got 2 long flashes and 1 short flash which turned out to be #21 so the ecu is telling me that code #21 is for the ignition system and theres a promlem with it...
so yeah to cut to the chase.. anyone that has a sr20det redtop can you take a picture of the wires where they connect to the blue plug that goes into the ecu so i could make sure that i have all the wires in its correct place.. thanks! Last edited by drojit_1; 06-26-2004 at 01:21 PM. |
|
|
|
06-27-2004, 03:23 PM
|
#2 |
|
Registered User
Join Date: Dec 2003
Location: san diego
Posts: 70
|
anyone?
i need a picture of the wires that go into the blue plug that goes into the ecu please!!! haha |
|
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
