 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
|||||||||||
|
|||||||||||
|
|||||||||||
|
|
|||||||
This is a discussion on Tanabe springs within the TECH Discussion Forum forums, part of the TECH Discussion category; Alright fellas heres the deal...I got tanabe springs....an di put them on...I also have an SR redtop in the car...heres ...
 |
|
|
Thread Tools | Rate Thread | Display Modes |
09-20-2004, 12:15 PM
|
#1 |
|
Dinosuars=Jesus Horses
Join Date: May 2004
Location: Ohio(Orlando)
Posts: 162
 |
Tanabe springs
Alright fellas heres the deal...I got tanabe springs....an di put them on...I also have an SR redtop in the car...heres the problem....i got a massive gap between the wheel and the body...is this because the SR engine is lighter and the springs are for the heavier KA?
|
|
|
|
09-20-2004, 01:07 PM
|
#2 |
|
Subway Pervert FD
Join Date: Aug 2003
Location: Back in the U.S. but wishing he were back in Japan
Posts: 963
|
yes I believe the engine is lighter. 2.0 vs. 2.4 and the ka is steel I believe (been a while since I've looked this up) the sr is aluminum headed. but that shouldn't matter too much. which version of the tanabe springs did you get. I can ask my friend about these...
|
|
|
|
|
09-20-2004, 01:48 PM
|
#3 |
|
Dinosuars=Jesus Horses
Join Date: May 2004
Location: Ohio(Orlando)
Posts: 162
|
Grip Feeling 210
|
|
|
|
|
09-20-2004, 04:37 PM
|
#4 |
|
Subway Pervert FD
Join Date: Aug 2003
Location: Back in the U.S. but wishing he were back in Japan
Posts: 963
|
ok i'll give him a call and find out for you
|
|
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
