 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
|||||||||||
|
|||||||||||
|
|||||||||||
|
|
|||||||
This is a discussion on Anybody tried making the KA transmission work on the SR? within the TECH Discussion Forum forums, part of the TECH Discussion category; From browsing the forums and the net, many claimed the internals of a SR tranny and the DOHC KA tranny ...
 |
|
|
Thread Tools | Rate Thread | Display Modes |
09-24-2004, 01:24 PM
|
#1 |
|
DRIVER
Join Date: May 2004
Location: Los Angeles, CA
Posts: 576
  |
Anybody tried making the KA transmission work on the SR?
From browsing the forums and the net, many claimed the internals of a SR tranny and the DOHC KA tranny are actually identical and that the DOHC KA tranny will fit a SR if the SR's bell housing is swapped over. Is it true? Many continue to say it is too time consuming for such a procedure but no one has actually claimed that they had done it and . FYI, it only took me half an hour to crack open a KA tranny. So I don't think it's that difficult. Anyway, any information regarding this will be appreciated.
__________________
Hubert Young KORE 8 Films |
|
|
|
09-27-2004, 08:48 AM
|
#2 |
|
Drift Assoc. - Lead Tech
Join Date: Aug 2004
Location: Ventura, CA
Posts: 257
|
It is cake, it works and it is the reason I have 2 spare trannys. It is super easy to swap out the bell housings and more often than not a 'blown' SR or KA tranny is simly when the shifter gets stuck in between gears. Which is SUPER easy to fix once the casing is apart.
Last edited by LOVMUFN; 09-27-2004 at 08:53 AM. |
|
|
|
|
09-27-2004, 05:57 PM
|
#3 |
|
Guest
Posts: n/a
|
yeh, like he said it works just fine with the SR.. it also bolts up to the CA (i'm pretty sure) and parts of it can be used on the RB20
|
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
