Engine Priming

bboyt3nsk · 10-28-2004, 07:21 AM

Ive been trying to get my redtop SR started for about a week now...Everything is on wired up and ready to go, for about a week, needless to say.
The only time I got it to start was when I primed it by putting gas in the intake manifold...it ran crappy but it ran. It ran for as much fuel I put in too. It eventually would bog down and stall. Now Im thinking this is an injector problem (not firing) Ive checked EVERYTHING and I am clueless.

LOVMUFN · 10-28-2004, 07:39 AM

Check to see if you put the proper gas line (the return line and the pressure line) in the right spot. It is something that people do every once and a while without thinking. I did it once.

Just switch the lines if that is the problem.

10-28-2004, 07:21 AM	#1
bboyt3nsk Dinosuars=Jesus Horses Join Date: May 2004 Location: Ohio(Orlando) Posts: 162	Engine Priming Ive been trying to get my redtop SR started for about a week now...Everything is on wired up and ready to go, for about a week, needless to say. The only time I got it to start was when I primed it by putting gas in the intake manifold...it ran crappy but it ran. It ran for as much fuel I put in too. It eventually would bog down and stall. Now Im thinking this is an injector problem (not firing) Ive checked EVERYTHING and I am clueless.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

10-28-2004, 07:39 AM	#2
LOVMUFN Drift Assoc. - Lead Tech Join Date: Aug 2004 Location: Ventura, CA Posts: 257	Check to see if you put the proper gas line (the return line and the pressure line) in the right spot. It is something that people do every once and a while without thinking. I did it once. Just switch the lines if that is the problem.